If you own an air-conditioner, but the temperature in your room is not lowering, then there may be some issue with the temperature control. The issue could range from simple problems to complex ones. Either way, there are a few things that you need to check out so that your air conditioner cooling system runs like a well-oiled engine.
1. Check the thermostat setting: First, check if your thermostat is set correctly. If it’s set too low, it will not turn on and cool your home. If it’s set too high, the AC will constantly run. Check your thermostat and set it correctly for how hot it is outside.
2. Dirty Air Filters: A dirty filter can decrease airflow through your cooling system and make it harder for your unit to cool properly. To check if your filter needs cleaning, remove it from its slot and hold it up to a light source. If you see dust or dirt on the filter, it needs to be cleaned or replaced immediately!
3. Blocked Condenser: A blocked condenser is also one of the reasons for not lowering the temperature. The condenser coil cools the refrigerant and removes heat from the air, so the air conditioner can’t do its job if it is blocked. To fix this problem, use an extension pole with a brush attachment to remove the blockage.
4. Damaged Heat Pump: A damaged heat pump can cause your air conditioning to malfunction. A heat pump is usually located in the attic and is operated by a thermostat. When the temperature drops below the set temperature, the heat pump turns on and pulls in air from outside. The air is warmed up and sent into the house through registers. If you suspect that your evaporator coil has frozen up, turn off the power to your unit and contact a professional AC Repair Services in Lynnwood WA.
5. Leakage in Refrigerant: Leaks or loss of refrigerant will lead to poor cooling performance. The air conditioner may cycle too often, and the outdoor fan may continue running even after the thermostat has stopped. This can drive up your electric bill, cause damage to the compressor, and shorten the air conditioner’s life. Inspecting the piping and suction lines is necessary to discover possible leaks or losses.